PLACID Accelerometer PLV 3010 02Y1 triaxial
TRIAXIAL TOP-EXIT CONNECTOR
Basics
The PLACID PQV 3010 02Y1 is a multi-purpose IEPE accelerometer.
Connectivity
The PLACID PLV 3010 02Y1 is an IEPE powered accelerometer. As the output impedance of our IEPE accelerometers is < than 100 Ohm, no special low-noise cable are required.
Uses
The PLACID PLV 3010 02Y1 is used for all forthcoming vibration measurements where a triaxial is required.
Individual calibration
All PLACID accelerometers are being calibrated in a controlled laboratory environment using traceable calibration equipment complying with ISO17025 standards.
We recommend that all PLACID accelerometers are re-calibrated every year to guarantee an optimized usage.
PLACID Traceable Calibration is performed by our qualified staff and under controlled conditions according to the procedures and standards such as ISO17025.
Quality
All PLACID accelerometers are made of high-quality materials that will ensure long stability and durability, even in harsh condition. PLACID offers 2 years warranty against defective materials and workmanship.
All our accelerometers are made from Stainless steel.
| DATASHEET PLACID PLV 3010 02Y1 ACCELEROMETER | ||
| GENERAL CHARACTERISTIC | ||
| Measurement Range(g) | 0.5—10000Hz | |
| Measuring Axis(single/triaxial) | Triaxial | |
| Voltage Sensitivity(±5%) | 10 mv/g | |
| Maximum Acceleration | ±500 g | |
| Shock (OverloadLimit) | 5000 g pk | |
|
Frequencyresponse |
±5% | 8000 Hz |
| ±10% | 10000 Hz | |
|
Amplitude Response |
±5% | 8000 Hz |
| ±10% | 10000 Hz | |
| Resonance Frequency | ≥70 kHz | |
| Non-Linearity | 1% | |
| Temperature Range | -40 to +120℃ | |
| Transverse Sensitivity | ≤5% | |
| Output Impedance | ≤100 Ω | |
| Output BiasVoltage | 8-12 VDC | |
| Grounding | Cable shielding layer | |
| Sensing elements | Piezoelectric ceramics | |
|
Sensing Geometry |
11mm x 11mm x 11mm | |
| DATASHEET PLACID PLV 3010 02Y1 ACCELEROMETER | |
| POWER REQUIREMENT | |
| Excitation Voltage(V) | Typical 24 VDC |
| Constant CurrentExcitation | Typical 4 mA |
| Supply Voltage(Unloaded) | 20 – 30 VDC |
| Constant CurrentSupply | 2 – 20 mA |
| PHYSICAL CHARACTERISTICS | |
| Housing Material | Titanium Alloy |
| Sealing | Crimping |
| Weight | 4.8 gram |
| ElectricalConnector | 1/4-28 4-Pin |
| Electrical ConnectionPosition | Side |
